Create an A$3$ title block to show the following information:

$$ Title of Drawing: Solar Installation $2024$

$$ Drawn by: Aubrey Kgotso Lebea

$$ Checked: SQ Buthelezi

$$ Approved: CS Shoba

$$ Revision: $1$

$$ A coloured logo of your choice $($drawn logo$,$ not a picture, be creative and create a logo$)$

Before you open the video please do the following: $($steps to create Title block$)$

$1.$ Open a new drawing

$2.$ Turn ORTHOMODE on by pressing F$8$

$3.$ Remove grids by pressing F$7$ or Fn $+$ F$7$ for most laptops

$4.$ Draw a rectangle by following the following steps:

$$ Type REC and press Enter

$*$Prompt$*$ Specify first corner: Enter $0,0$ and Enter

$$ Drag the cursor upwards to specify which area to draw the rectangle

$*$Prompt$*$ Enter Dimension: Type D and Enter

$*$Prompt$*$ Specify length for rectangles: $420$ and Enter

$*$Prompt$*$ Specify width for rectangles: $297$ and Enter

$*$Prompt$*$ Specify other corner: Click inside the rectangle and Enter

$$ Zoom in by scrolling $0,0$

$$ the mouse scroll wheel in the downwards direction until you can see the full rectangle that you just

drew. This is now the basis of your A$1$ title block

$$ Type OFFSET and Enter

$*$Prompt$*$ Specify offset distance: Type $5$ and Enter

$$ Click the rectangle and then click the inside area of the rectangle to create a smaller rectangle.

$$ Type EXPLODE and Enter

$$ Select the smaller rectangle and Enter

$$ Type COPY and Enter

$$ Select the right vertical line of the smaller rectangle and press Enter

$*$Prompt$*$ Specify base point: Click anywhere near the centre of the rectangle and move your cursor

to the left to indicate the direction you want your line to be drawn.

$$ Type $75$ and Enter

The drawing must be plotted as PDF and you send the PDF Plot of the drawing.