Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

(D Use two pieces of wire to make connections between the springs on one of the light bulbs to the springs on the D-cell in

image text in transcribed
image text in transcribed
(D Use two pieces of wire to make connections between the springs on one of the light bulbs to the springs on the D-cell in such a way that the light will glow. Discuss with your lab partner before you begin actually wiring your circuit which connections you intend to make, and why you think you will be successful in activating the light. If you are not successful, try in order: changing the wiring, using another light, using another cell, asking the instructor for assis- tance. a) Sketch the connections that the wires make when you are successil, using the symbols from the rst page of this lab. b) Re-sketch the total circuit that you have constructed, making the wires run horizontally and vertically on the page. This is more standard in terms of drawing electrical circuits. Reverse the two wires at the light. Does this have any effect on the operation? Reverse the two wires at the cell. Does this have any effect on the operation? In the following steps, use the pushbutton switch as shown on the right. @ Use additional wires as needed to connect a second light into the circuit in such a way that it is also lighted. (Use the switch to turn the power on and off once the complete wiring has been achieved.) Discuss your plans with your lab partner before you begin. Once you have achieved success, sketch the connec- tions that you made in the form of a circuit diagram. Armotate your circuit diagram by making appropriate notes to the side indicating what happened with that particular circuit. If you experience lack of success, Figure 1 _1 keep trying. > NOTE: Is your original light the same brightness, or was it brighter or dimmer that it was during step 1? Can you explain any differences in the brightness, or the fact that it is the same? If not, don\"t be too surprised, as this will be the subject of future study. C53 If you can devise another way of connecting two lights into the same circuit, try it out. Sketch the circuit diagram when nished and note the relative brightness. Compare your brightness with what you achieved with a single light by itself. @ Disconnect the wires and return them to the plastic bag. Replace the equipment to its storage case

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image_2

Step: 3

blur-text-image_3

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Design And Analysis Of Experiments Vol. 1

Authors: Klaus Hinkelmann

1st Edition

0471727563, 9780471727569

More Books

Students also viewed these Physics questions