Design a microcomputer system using a uP $808610$ Mhz$.$

This system must have a Coprocessor $8087,$ a parallel connector, a serial connector, ADC and DAC connector for data conversion, a $16$ byte seven segment display, a $64-$key matrix keyboard, a USB connector thru a DMA for high speed data transfer. A special connector to connect a printer. The system must have an interrupt controller to handle all the I$/$O interface. The main memory size will be $1$ Mbyte.

Show all the diagrams needed to construct your design including all the I$/$O interface and devices connected, show a memory map and the type of memory you will need for you design including the configuration and decoding system. You must include the programming needed for set up the complete system. Use pseudo code for each driver and program each of the interface needed.

PLS PROVIDE THE DIAGRAMS WITH ASMUCH DETAIL AS POSSIBLE YOU CAN USE A BLOCK DIAGRAM $($A writen in paper diagram would be nice but if you cant atleast provid which pins connect where like "connect the clk pin$(8)$ of $8284$ to the $8086$ clock pin$(19))$ Now this is a example im not expecting you to pain stakingly adress every pin like before but if a very important connection is neded pls address it$.$ ALSO NOTICE THE DESIGN MUST BE IN MAXIMUM MODE $($those includes the $8288$ control buss etc..$)$

THE PSEUDOCODE MUST BE IN ASSEMBLY $($Keep in mind its a $8086$ microprosecor$).$