Design Project Directions: (Letter h on page 72 in your textbook) Design a little wrench for loosening and tightening nuts and bolts of a bicycle. The nut size is 5/8 inch (15mm), and the required torque is about 1.0 lb-ft (1.356 N-m). Assume production volume is 10,000 pieces. Your submission must be completed using a computer except for the drawing. The drawing will not be drawn free hand, but with CAD software or drafting tools. Submission: Your.pdf submission must have the following information: Two neatly dimensioned graphical projections of the product (i.e., a blueprint ready to be released to the workshop for actual production), including fits (if applicable), tolerances, surface finish marks, an so on. Material selection with rational justification Selection of the specific manufacturing processes required, as well as their sequence in detail, Design Project Directions: (Letter h on page 72 in your textbook) Design a little wrench for loosening and tightening nuts and bolts of a bicycle. The nut size is 5/8 inch (15mm), and the required torque is about 1.0 lb-ft (1.356 N-m). Assume production volume is 10,000 pieces. Your submission must be completed using a computer except for the drawing. The drawing will not be drawn free hand, but with CAD software or drafting tools. Submission: Your.pdf submission must have the following information: Two neatly dimensioned graphical projections of the product (i.e., a blueprint ready to be released to the workshop for actual production), including fits (if applicable), tolerances, surface finish marks, an so on. Material selection with rational justification Selection of the specific manufacturing processes required, as well as their sequence in detail