Design_and_Measurement_Test_2021.... a https:api.schoo|ogy.comv1attachment2344690164sour... Design and Measurement Test Part 1 1. Find the volume of a sphere with a radius of 10 cm. (Three marks) 2. Find the surface area of a cylinder with a radius of 6 cm and a height of 10 cm. (Three marks) 3. Find the area of this figure (Four marks) l.. 9feet l 4. Covert each of the following to two decimals (Two marks each; show work or you WILL NOT get full marks) a) 10 sq yrds = sq ft b) 86 inches = feel: it) 225 mm = cm d) 43 m3 = cu ft e) 250 mL = fl oz 10f2 Design_and_Measurement_Test_2021.... a 5. Cast of Design problem (Eight Marks) 4. Jade wants to build a deck using the dlagrarn(top view) to the right as a guide. There are two different pieces of wood used to construct the top of the deck. There Is a 1' x 6' piece used on the ends to make the shorter piece that appears. There Is also a 1' x 12' piece that appears everywhere else (the longer piece). Jade needs to put support posts under the deck, as lllustmted In the diagram (top View) to the right. Jade also wants to put a ore-stained lattice railing and pro-stained flat benches around 3 sides of the deck (leaving one of the longer sides of the deck open). Finally, Jade will stain her deck, too. Here Is some Information about the costs Involved: Each 1' x 6' piece is $6 Each 1' x 12' piece ls $10 Each support post is $8 Each llnear foot of pre-stalned railing costs $7 Each linear foot of pre-stalned bench costs $12 Each can of deck staln covers 50 sq ft and costs $39 one... How much will It cost to build and stain the deck (before taxes)