Direct Method, Reciprocal Method, Overhead Rates Macalister Corporation is developing departmental overhead rates based on direct labor hours for its two production departments-Molding and Assembly. The Molding Department employs 23 people, and the Assembly Department employs 81 people. Each person in these two departments works 1,960 hours per year. The production- related overhead costs for the Molding Department are budgeted at $235,000, and the Assembly Department costs are budgeted at $82,000. Two support departments- Engineering and General Factory-directly support the two production departments and have budgeted costs of $215,000 and $353,000, respectively. The production departments' overhead rates cannot be determined until the support departments' costs are properly allocated. The following schedule reflects the use of the Engineering Department's and General Factory Department's output by the various departments. Engineering hours Square feet Engineering 114,000 General Factory Molding Assembly 2,100 2,100 376,200 7,900 79,800 For all requirements, round allocation ratios to four significant digits and round allocated costs to the nearest dollar. Required: 1. Calculate the overhead rates per direct labor hour for the Molding Department and the Assembly Department using the direct allocation method to charge the production departments for support department costs. Round final answers to the nearest cent. Molding Assembly Overhead rate per DLH 14.83 X 2.38 X 2. Calculate the overhead rates per direct labor hour for the Molding Department and the Assembly Department using the reciprocal method to charge support production departments for support department costs. Round final answers to the nearest cent. Molding Assembly Overhead rate per DLH 14.83 X 2.38 X 2. Calculate the overhead rates per direct labor hour for the Molding Department and the Assembly Department using the reciprocal method to charge support department costs to each other and to the production departments. Round final answers to the nearest cent. Round your intermediate calculations to four decimal places. Molding Assembly Overhead rate per DLH 14.39 X 2.51 X 3. Explain the difference between the methods, and indicate the arguments generally presented to support the reciprocal method over the direct allocation method. (CMA adapted) The reciprocal allocation method is preferred because it recognizes that all support departments serve one another