Download Cisco Packet Tracker from the list of tools and install it either in your computer or in a Windows virtual machine$\mathrm{.}1.$ Drag & drop a Cisco $2911$ router. In the CLI, execute sh version. What is the configuration registers value?$2.$ What the leading $0$x means?$3.$ According to this value, what bits are enabled? Write down the bit numbers or positions$\mathrm{.}4.$ What is the hexadecimal value for the boot field? What does it mean?$5.$ Change the boot field to $0$x$00,$ but let all other bits unchanged. What command did you execute?$6.$ Execute reload to restart the router. What the prompt looks like?$7.$ From there, you will be able to completely boot with the command boot. Now set the register so that the boot field is $0$x$02,$ diagnostic messages are enabled and NVRAM content ignored; everything else unset or diabled. What value did you set?$8.$ Execute again reload. Then, en and config t$.$ What options do you have when executing boot $?($as listed below the command, one per line$)?9.$ Verify the system flash from the CLI. Capture a screenshot of the command you used and its output$\mathrm{.}10.$ To show information about the IOS license in a real router you might use show license. However, this does not work in Packet Tracker. What command would you use to list all showing options beginning with l$?$