fasstt please!!

Assign subnetwork addresses to the Topology Diapram and determine interface addresses according to the conditions below. 1. Assign subnet 1 in the 192.168.1.0 network to the WAN link between the HQ and BRANCH routers 2. Assign subnet 2 in the 192.168.1.0 network to the LAN attached to the HQ router. 3. Assign the first valid host address in the 209.165.202.128/27 network to the LAN interface on the ISP router. 4. Assign the last valid host address in the 209.165.202.128/27 network to PC3. 5. Assign the first valid host address in the 209.165.200.221/30 network to the WAN interface of the ISP router. 6. Assign the last valid host address in the 209.165.200.224/30 network to the Serial 0/0/1 interface of the HQ router. 7. Assign the first valid host address in the HQ LAN network to the LAN interface of the HQ router 8. Assign the last valid host address in the HQ LAN network to PC 2. 9. Assign the first valid host address in the HQ/BRANCH WAN link to the Serial 0/0/0 interface of the HQ router. 10. Assign the last valid host address in the HQ BRANCH WAN link to the Serial 0/0/0 interface of the BRANCH router. 11. Assign the first valid host address in the 10.10.2.0/23 network to the LAN interface on the BRANCH router 12. Assign the last valid host address in the 10.10.2.0/23 network to PCI. Fill the following addressing table according to the conditions above. Device Interface IP Address Subnet Mask Default gateway N/A BRANCH Fa0/0 S0/0/0 N/A HQ Fa0/0 N/A SO/0/0 N/A SO/0/1 N/A ISP Fa0/0 N/A SO/0/1 N/A PCI NIC HQ S0/0/0 Fa0/0 S0/0/0 S0/0/1 Fa0/0 S0/0/1 NIC NIC NIC NA N/A N/A N/A N/A N/A ISP PCI PC2 PC3 After cabling the network in the topology diagram and completing the basic configuration do the following: 1. Test connectivity between the devices on the network. First test the connections between directly connected devices, and then test connectivity between devices that are not directly connected 2. RIP Routing must be configured on the BRANCH Router 3. RIP and default Route must be configured on the HQ Router. 4. Static Routing must be configured on the ISP Router. 5. View the routing table after each static or dynamic route is added to observe how the routing table has changed. 6. Show your work to the lab supervisor. Are there any router interfaces that do not need to have RIP updates sent out? What command is used to disable RIP updates on this interface? The HQ router needs to send the default route information to the BRANCH router in the RIP updates. What command is used to configure this