fill the blanks

Answer each of the following 6 questions for the flip-flop specified by the logic symbol shown in the following figure. Please select your answers from the following: NAND, NOR, zero, latch, one, invalid, clock level, negative edge, BCD. positive edge, level- triggered, decoder, encoder, high-impedance, 00, 11, 10, 10. If the answer is NOT found and you think that your answer is correct, please write it instead. FFwsetrese 2.jpg B. - D Q D Q D D Q D D Q FF#2 FF#3 FF#4 FF#1 C D p> R R R s - Q J Q Q FF#5 Q FF#6 FF#7 J FF#8 C K K Q K Q K Q R The FF#1 flip-flop operates normally and changes its state on the Blank 1 of the clock pulse. In FE#1, the asynchronous inputs (SR) sets/clears the flip-flop when they are in Blank 2 state. If D=0, S=O, R = 0, then FF#1 goes to Blank 3 state on the active edge of the clock pulse. The FF#1 flip-flop operates normally and changes its state on the active edge of the clock pulse, when both S and R are in Blank 4state. If D=0, S=1, R = 0, then FF#1 goes to Blank 5 state regardless of the clock pulse and the value of Dinput. To clear the flip-flop FF#1, you have to make the asynchronous inputs SR= Blank 6