Follow the procedure to configure your topology:1. 2. A-End Interface Name Z-End Interface Name

Define the topology like figure#1, use the routers and switches have the right amount of interfaces. Each router and switch expects to have the EST timezone, hostname (initial#), enable password "cisco" and secret password "TELE33324".

Define the interfaces by use the following information:

Subnet for the point-to-point

R1 G0/0

R2 G0/0

10.0.0.4/30 (IPv4)

2607:f798:10:0:0:4::/127 (IPv6)

R1 G0/1

R4 G0/1

10.0.4.8/30 (IPv4)

2607:f798:10:0:4:8::/127 (IPv6)

R2 G0/1

R3 G0/1

10.0.7.16/30 (IPv4)

2607:f798:10:0:7:16::/127

R4 G0/0

R5 G0/0

10.0.8.20/30 (IPv4)

2607:f798:10:0:8:20::/127

R5 G0/1

R3 G0/0

10.0.9.24/30 (IPv4)

2607:f798:10:0:9:24::/127

R3 G0/2

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

PC1

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

PC2

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

PC3

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

PC4

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

PC5

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

PC6

Switch

8.0.0.0/24 (IPv4)

2607:f798:8::/64

Ping each point-to-point interface on both IPv4 and IPv6 to ensure connectivity works fine.

3. Configure the PC to ensure it has IP, subnet mask and default gateway for both IPv4 and IPv6.

Ping from R3 to each PC to ensure the connectivity is fine.

4. Configure Loopback address for each router and switch as below:

Device Name

Loopback0 IP

R1

7.0.0.1/32

2607:fea8::1/128

R2

7.0.0.2/32

2607:fea8::2/128

R3

7.0.0.3/32

2607:fea8::3/128

R4

7.0.0.4/32

2607:fea8::4/128

R5

7.0.0.5/32

2607:fea8::5/128

Switch#1

7.0.0.6/32

2607:fea8::6/128

When the loopback interfaces is down, are the interfaces up and running?

Make sure no shut all the loopback interfaces after testing.

5. Enable RIP among each router's neighbor. Which version of RIP are you using and why?

6. Go to R1 and check the route to 8.0.0.2 PC#1 and see which path is taken. Why? Save 1st pkt

7. Verify with a traceroute from R1 to PC1 for the actual path.

8. Check out the routing table for all routers:

R1> show ip route

R1> show ip protocol