For the figure below, write a CNC program using cutter diameter compensation. Reference point (machine home) 24 -500- 10 .500 1.750 1.188 .968 500- 2.438 2.063 1.427 R.625 12 .375 R.563 19 918 .938 20 + 210 15 R.375 22 .750- 1.500- 1.625 FIGURE 12.15 Print and tool paths for 12.2. CNC Tool and Operations Sheet 017 Programmed path Path of the cutter center 70127 .219 Tool Operation Tool Details Spindle 1 Finish outside and inside profiles as shown 14" DIA Speed (rpm) 1200 Feed rate (ipm) 8 End Mill 01210 (XOYO IS THE UPPER LEFT HAND CORNER OF THE PART) (ZO IS THE TOP OF THE PART) (TOOL#1 1/2 DIA END MILL) N10 G90 G20 G40 G80 N20 G91 G28 X0 YO ZO N30 G92 X10.0 Y5.0 ZO. (1) N40 T1M6 (TOOL#1: FINISH OUTSIDE AND INSIDE PROFILE x .23 DEEP) N50 GO G90 X (1) Y (2)_ ZO. S1200 M3 (2) N60 G43 Z.1 H1 N70 M8 N80 G1 Z-.23 F8. N90 G4 (3) X_(4) _____ Y_(5) _ D1 (3) N100 X (6) (4) N110 G (7) _ _(8)__ Y____(9)____ |___(10) ___ J__( ) _ (5) N120 G1 Y (12)_(6) N130 X (13) _Y_ (14)_(7) N140 X (15)_ (8) N150 G (16) __X_(17)___ Y___(18) _ |_ (19) _J_ (20) _ (9) N160 G1 Y (21)__ (10) N170 X.5 Y (22) _ (11) N180 G (23) ____(24)__Y___(25)_ |__(26)____ J_(27)__ (12) N190 G1 G40 X_(28)_Y_(29) _ (13) N200 GO Z.1 N210 X (30) Y_(31) (14) N220 G1 Z-.23 N230 G4 (32)_X__(33)_ Y_(34) __ D1 (15) N240 X (35) (16) N250 X (36) _ Y_ (37) _ (17) N260 Y (38)_ (18) N270 X (39) (19) N280 G (40) X__(41)_Y__(42)_ (43)_J_(44)_(20) N290 G1 Y (45)_(21) N300 X (46) _ (22)