For the question on the following pages, call the initial pre-shock point: A; and call the after-shock point: B. I should see (only) points A and B in both graphs on the left side where you show the shock on the AE curve on the above graph, and on the Phillips curve on the lower graph (both drawn and labeled carefully). In the first part illustrate the shock described in the question using the AE/PC model without time lags as shown in Ch.12 in the textbook (use the AE and PC graphs similarly to the textbook). For your analysis, choose as a starting point (marked A) an economy operating at potential GDP and at its inflation target. Also on the left side show point B where the economy is situated after the shock but prior to any Bob policy response. There should be an A and B on BOTH the upper and lower graphs. If points A and B are the same point then just mark that point with both an A and a B. Using the two graphs on the right side you'll show the Fed policy response. Start on the right side, showing starting-point B on both the upper and lower graphs. Indicate where the economy is situated immediately after the described Fed response using a point C. The movement from B to C is strictly the Fed policy action and how it is represented in AE and PC models. There should be a points B and C on both the upper and lower graphs. You'll notice that the economy will be in a recession at point C. You'll want the economy in a recession for only one period so the PC can return to its original position and then you'll want to have your point D at the long-run equilibrium to avoid disinflation, so the PC is stable at its original position. Note: If you have a letter on the top graph you must indicate the associated position using that letter on the bottom one (so if there is an 'X' on the top graph then there must be an 'X' on the bottom graph, and they must be vertically aligned for consistency. As an example of a common error: if B is located at Y>Y* on the upper graph then it makes no sense to have Bat Y=Y* (or Y