For the tricolor LED and lite bulb Circuit shown in Figure 1, write an UNO program that will turn on/off the 3 LED's in the tricolor (red, blue and green) in the following sequences: (a) Turn on the 6 V dc light bulb by itself for 2.5 seconds, then turn off. (b) light up the Red LEO by itself for 1.5 seconds, then turn off. (c) Light up the blue LED for 1 seconds, then turn off. (d) Light up only the yellow LED for 2 seconds, then turn off. (e) Light up the Red and Yellow LED's together for 1.5 seconds, then shut off both. (f) Light up the Red and Blue LED's for 3 seconds, then shut off both (g) Light up the Yellow and Blue LEDs for 2 seconds, then turn off both. (h) Light up all 3 LED's for 2 seconds, and at the same time flash the Light Bulb at a 3 Hz rate (I.e. bulb lights for 0.166 seconds, then shuts off for 0.166 seconds repeatedly). Finally shut off all lights after 4 seconds. (i) Refer to circuit diagram and parts list in figure 1 of attached diagram sheet for the electronic circuit operation. For the tricolor LED and lite bulb Circuit shown in Figure 1, write an UNO program that will turn on/off the 3 LED's in the tricolor (red, blue and green) in the following sequences: (a) Turn on the 6 V dc light bulb by itself for 2.5 seconds, then turn off. (b) light up the Red LEO by itself for 1.5 seconds, then turn off. (c) Light up the blue LED for 1 seconds, then turn off. (d) Light up only the yellow LED for 2 seconds, then turn off. (e) Light up the Red and Yellow LED's together for 1.5 seconds, then shut off both. (f) Light up the Red and Blue LED's for 3 seconds, then shut off both (g) Light up the Yellow and Blue LEDs for 2 seconds, then turn off both. (h) Light up all 3 LED's for 2 seconds, and at the same time flash the Light Bulb at a 3 Hz rate (I.e. bulb lights for 0.166 seconds, then shuts off for 0.166 seconds repeatedly). Finally shut off all lights after 4 seconds. (i) Refer to circuit diagram and parts list in figure 1 of attached diagram sheet for the electronic circuit operation