Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Given an Arduino UNO microcontroller with the following added modules: AC Relay connected as follows: 5v pin, GND pin, and PIN12, its output is connected
Given an Arduino UNO microcontroller with the following added modules: AC Relay connected as follows: 5v pin, GND pin, and PIN12, its output is connected to a 220v water pump via the NO and COM ports. Bluetooth Module connected to 5v pin, GND pin , Tx pin , Rx pin If the above system receives a message from the connected Bluetooth device with the letter "S" it starts the water pump until it receives another message with the letter "p". Draw a figure that represents the above system architecture and right the proper code that will enable the system to run correctly as described
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started