help me with this thank you!

1. Access the simulation application through this link: http://ch301.cm.utexas.edu/simulations/js/idealgaslaw/ 2. Familiarize yourself with the buttons and controls of the application. Refer to the figure above. 3. Before you start, make sure that the simulator is on its initial set-up. They are as follow: Volume: 0 L Pressure: 0.00 atm Temperature: 10 K You can adjust both the volume and pressure by clicking the release valve. You can adjust the temperature by clicking cool until it reaches the desired value, then click off. 4. Select Gas A from the Gas Selector. 5. Press the Pressure Control once, then click the volume control until reads 1000L. Lock the volume monitor. This will be our constant volume throughout the activity. 6. Adjust the temperature based on the table below. Record the pressure. 7. Do the same procedure again then get the average of the results. 8. Answer the guide questions that follow. DATA: Table 4.1. Gas Law Set-up Results (10 points) Temperature Pressure (atm) Trial 1 Trial 2 Average 50 K 200 K 150 K 300 K 250 KGUIDE QUESTIONS: 1. What happens to the pressure as you increase the temperature of the set-up? (2 points) 2. What happens to the pressure as you decrease the temperature of the set-up? (2 points) 3. How would you describe the volume of the air during the observation? (2 points) 4. How are you going the describe the relationship between temperature and pressure? Explain. (2 points) 5. In conclusion, state the relationship between temperature, pressure, and volume based on the activity. (3 points) APPLICATION: Propane tanks are used as a portable source of fuel for cooking. To monitor the amount of gas inside this tank, a gauge is attached to it which reads the pressure inside the tank. The gauge measures pressure and will register a higher pressure on a hot day than it will on a cold day. Why is that so? Explain. (4 points)