Hi. I *need Proteus 7 design* for this and *atmel studio 7 coding* for run this as required. Yesterday I posted same question in Chegg and get wrong answer. Take your time. But please. I need a good answer. Coding not long also no problem. Proteus run well correctly enough. Thanks in advance.

Temperature Detection System Display temperature value based on switch selection as shown in truth table Main Devices in Proteus Design LCD Temp Select : Temp X TempX = C 2 toggle switches 1 LCD 4 Temperature Sensor ATMega -SW2 Temp Sensor 1 Temp Sensor 2 Temp Sensor 3 Temp Sensor 4 32 -SW1 Note Example: 1. When SW1 and SW20 (not pressed), LCD display should display Temp Select: Temp 1 and TempX = 20C 2. When SW1 = 0 AND SW2 = 1, LCD should display Temp Select: Temp2 and TempX = 40C 3. When SW1 = 1 AND SW2 = 0, LCD should display Temp Select: Temp3 and TempX = 60C should be display 4. When SW1 = 1 AND SW2 = 1, LCD should display Temp Select: Temp4 and TempX=80C should be display SW1 SW2 Select O o 0 1 Value Temp 1 Temp2 Temp3 Temp4 1 O 20C 1 1 40C Temp Sensor 1 = Temp Sensor 2 = Temp Sensor 3 = Temp Sensor 4 = 60C 1. Need Proteus Design fullfill this requirement. 80C 2. Need ATMEL Studio 7 coding/program to run the proteus design (code for ATMEL Studio 7)