HQ- Fa0/24 Fa0 Gig0/1 NTP Server Gig0/0/0 Fa0 PC1 Se0/1/0 Gig0/0/1 Gig0/1 Fa0/1 Fa Fa0/3 Fa0 PC4 Se0/1/0 Branch Fa0 PC5 Gig0/0/0 Gig0/1, Gig0/2 Gig0/2 BR-SW Fa0/24 Gig0/1 PC3 BR- Fa0/1 Fa0 Fa0/24 Fa0/24 BR/SW 3 Fa0/2 Fa0/1 Fa0/2 Fa0 PC6 Fa0 Fa0 PC2 PC7 PC1 PC4 PC5 PC2 PC3 PC6 PC7 Device BR-SW1 BR-SW2 BR-SW3 NIC NIC NIC NIC NIC NIC NIC Interface Instructions Use the table below to logon to the Branch switches when you need to do so. Device User Password Username UTAS1admin# UTAS2admin# UTAS3admin# IP Address 192.168.2.10 192.168.2.11 192.168.2.12 192.168.4.10 192.168.4.20 192.168.4.30 192.168.4.40 admin admin admin Note: Click the Fast Forward Time button in the blue bar below the topology to speed up STP convergence. You can also click it several times to speed up the CDP update process. Enable Secret UTAS1EnaAccess# UTAS2EnaAccess# UTAS3EnaAccess# Configure LLDP as follows: Disable CDP on the HQ router. Enable LLDP globally on HQ. On HQ, configure the links to the switches to only receive LLDP messages. Disable CDP on the HQ-SW-1 and HQ-SW-2 switches. Enable LLDP on the HQ-SW-1 and HQ-SW-2 switches. On the HQ-SW-1 and HQ-SW-2 switches, configure the links to the HQ router to only send, not receive, LLDP messages. Disable LLDP completely on the HQ-SW-1 and HQ-SW-2 access ports that are in use. Configure CDP as follows: Activate CDP on the Branch router. Connect to switch BR-SW1 over SSH. You will not be able to open a CLI window by clicking the Branch switches. Connect to switches BR-SW2 and BR-SW3 over SSH. Configure the access ports that are in use to not send CDP messages out of ports. Configure NTP: Configure HQ to use the device at 192.168.10.254 as an NTP server.