Question
) (i) Check that the centre to centre spacing of the bolts on the pitch circle is not too great [end of C1. 3.21.4.1
) (i) Check that the centre to centre spacing of the bolts on the pitch circle is not too great [end of C1. 3.21.4.1 referring to Cl. 3.21.6.2 and Cl. 3.21.11.2 for notation Table B3 assuming flange steel is same steel as vessel, and Table 3.21.11.4 for properties of gasket materials when used on flanges with full face gaskets]. (ii) Check that there is adequate spanner room (refer to the tables for spanner (aka wrench) clearances given in the e-reserve reference in Activity 6F of Topic 6)
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access with AI-Powered Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started