ISP AbcX_R1 200.1.50.36 fo/0 fi/o Switch fo/1 f0/0 10.1.1.1 f1/2 200.1.50.35 f0/0 AbcX_R2 f1/1 DHCP-Router fo/0 TASK A: 1) Create the topology as shown and rename all the routers as per the format given in Lab1 - Getting Started. 2) Give the required IP address on 'DHCP-Router'. 3) Configure 'Router' to use DHCP such that it assigns IP address to R1 and R2 and make sure to exclude IP address from 10.1.1.1 to 10.1.1.10 from the DHCP pool. 4) Verify that the IP addresses are being assigned and DHCP is working properly. ATTACH SCREENSHOT OF SHOW IP INTERFACE BRIEF' ON R1 AND R2 TASK B: 1) Configure the inside and outside NAT on 'DHCP-Router'. 2) Create an access list to permit all the inside addresses. 3) Configure NAT overload on the 'Router'. 4) Verify if the IP addresses are being translated. ISP AbcX_R1 200.1.50.36 fo/0 fi/o Switch fo/1 f0/0 10.1.1.1 f1/2 200.1.50.35 f0/0 AbcX_R2 f1/1 DHCP-Router fo/0 TASK A: 1) Create the topology as shown and rename all the routers as per the format given in Lab1 - Getting Started. 2) Give the required IP address on 'DHCP-Router'. 3) Configure 'Router' to use DHCP such that it assigns IP address to R1 and R2 and make sure to exclude IP address from 10.1.1.1 to 10.1.1.10 from the DHCP pool. 4) Verify that the IP addresses are being assigned and DHCP is working properly. ATTACH SCREENSHOT OF SHOW IP INTERFACE BRIEF' ON R1 AND R2 TASK B: 1) Configure the inside and outside NAT on 'DHCP-Router'. 2) Create an access list to permit all the inside addresses. 3) Configure NAT overload on the 'Router'. 4) Verify if the IP addresses are being translated