Just part A

2. [12 pts] An Arduino Uno must be wired and programmed such that: a normally-closed push-button is wired to pin 8 - the board-mounted LED attached to pin 13 will blink on and off continuously for as long as a user holds the button down the blinking should stop when the user releases the push-button. - Code for this operation is shown below at the left. You must: a. b. Correct three simple errors (there are four) in the code. Correctly wire the circuit using the push-button and resistor shown at the right of the Arduing void setup) pinMode ( 13, INPUT) pinMode(8, OUTPUT); int button pressed; void loop) button_pressed digitalRead(8); LOO while(button pressed0 ARDUINO button _pressed digitalRead(8): while(button pressed digital Write( 13, HIGH); delay(100); digital Write( 13, HIGH): delay(100) button pressed - digitalRead(8)