Lab Activity 1: Charging and Discharging of RL Circuit Construct the circuit shown in Figure 1 below. The resistor is the round bulb on the same circuit board as the switch. Because we do not want to accidentally leave the batteries connected to the circuit, in this lab, we will only use position A of the switch. Position A requires the switch to be held to keep it closed. Also make sure that the light bulbs (and connector screws) are properly screwed into their sockets. Figure 1 A circuit with the batteries and a light bulb. Please ask your teaching assistants if you are unsure about your wiring of the circuit. Throw the switch to A for a few moments and observe the light bulb. Throughout this lab, wait at least thirty seconds between runs to ensure that the light bulb cools. Q1. What happens to the light bulb when the switch is thrown to A (this is not a trick question, just describe what happens)