Let's sworn to the PRUT simulation Wave on a String. Click on the image below to open the 4 Create the following pattern using the s Batters warns the Picdul settings below The parture shines b pulses initially moving to the right Settings Amphaste 1.Oom, Fiber With - 11 2x, Select Loose Fod S Select the Pulse feature at the top right of the simulation. Then yet Dumping to zero. To create interference set the simulation to Slow Motion mode. Create one pulse by hitting the g Pulse button. Once the pulse travela a small distance (as shown below). hit PAUSE. Adja the Amplide and Pulse Width according to the situation depicted and hit Pulse again (PAUSE off at this point. When the wave travels down the string, it will encounter either a Loose End or a Fixed Bid and then reflect back. The two pulses will then interfere. Miska up of the STEP button to observe the in Sketch the interference pat era once the two pulses completely overlap each other. Scale the pattern appropriately. Sketch directly onto the picture below Final Amplitude Type of Interference Page 11 of 16 Page 12 of 16 2 Create the following pattern using the Pulse settings below. The picture shows both pulses initially moving to the right 3. Create two different sized pulses by hitting the pause button to make the necessary Settings Amplitude - 1.0em, Pulse Width - 0.2s, Select Fixed End changes for the second pulse. Each pulse will have a width of 0.20s and the picture helow shows both pulses initially moving to the right. Sketch the interference pattern once the two pulses completely overlap each other. Scale the pattern appropriately. Sketch directly onto the picture below Sketch the interference pattern once the two pulses completely overlap each other. Scale the pattern appropriately. Sketch directly onto the picture below D Final Amplitude: Type of Interference Final Amplitude: Type of Interference Page 13 of 16 Page 14 of 16