Light Bulb: R1=200 10V R2 =100 Switch R, = ? Figure 1: Use this diagram to fill in Table 1(a). Table 1(a): Using Figure 1, determine the values in this table. R I V P R1 Rz Ra Net 0.2 A 1. Using Figure 1, determine the values of the resistance, voltage drop, current, and power rating of each resistor in the circuit, along with the net for each value in the circuit. 2. Design the circuit in the "DC Construction Kit" simulator. Add three resistors, and right click on each one to change their value to the resistance of the resistors in Figure 1. Add a battery, and do the same to change its voltage. 3. Connect everything with wires, the current should begin to flow. You can measure the current through each resistor with the ammeter