Metal Accessories manufactures auto roof racks in a two-stage process that includes shaping and plating. Steel alloy is the basic raw material of the shaping process. The steel is moulded according to the design specifications of automobile manufacturers (Ford and General Motors). The Plating Department then adds an anodized finish At March 31, before recording the transfer of cost from the Plating Department to Finished Goods Inventory, the Metal Accessories general ledger included the following account: B(Click the icon to view the T-account.) Additional information included i (Click the icon to view the additional data.) Requirements mo ang Work in Process Inventory-Plating March 1 balance 26,370 Transferred-in from Shaping 28,800 Direct materials 28.600 Direct labour 20.867 Manufacturing overhead 36.763 Print Done th Additional information th The direct materials (rubber pads) are added at the end of the plating process. Conversion costs are incurred evenly throughout the process. Work in process of the Plating Department on March 1 consisted of 600 racks. The $26,370 beginning balance of Work in Process-Plating includes $14,400 of transferred-in cost and $11.970 of conversion cost. During March, 3.000 racks were transferred in from the Shaping Department. The Plating Department transferred 2,200 racks to finished goods inventory in March and 1,400 were still in process on March 31 This ending inventory was 50% of the way through the plating process Print Done Requirements ne 1. Fill in the time line for the Plating Department. 2. Prepare the March production cost report for the Plating Department 3. Journalize all transactions affecting the Plating Department during March, including the entries that have already been posted. e li Print Done