Mickley Corporation produces two products, Alpha6s and Zeta7s, which pass through two operations, Sintering and Finishing. Each of the products uses two raw materials-X442 and Y661. The company uses a standard cost system, with the following standards for each product (on a per unit basis): Product Alpha Zeta Raw Material X442 4661 1.8 kilos 2.0 liters 3.0 kilos 4.5 liters Standard Labor Time Sintering Finishing 0.20 hours 0.80 hours 0.35 hours 0.90 hours Information relating to materials purchased and materials used in production during May follows: Material X442 Y661 Purchase Purchase Cost 14,500 kilos $52,200 15,500 liters $20,925 Standard Price $3.50 per kilo $1.40 per liter Used in Production 8,500 kilos 13,000 liters The following additional Information is available: a. The company recognizes price variances when materials are purchased. b. The standard labor rate is $19.80 per hour in Sintering and $19.20 per hour in Finishing. c. During May. 1.200 direct labor-hours were worked in Sintering at a total labor cost of $27,000, and 2,850 direct lobor hours were worked in Finishing at a total labor cost of $59,850. d. Production during May was 1.500 Alpha6s and 2,000 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct lobor 2. Compute the materials price and quantity variances for each material. 3. Compute the labor rote and efficiency variances for each operation Complete this question by entering your answers in the tabs below. ne