Objectives: This lab introduces the MSP432 board and booster pack from Ti and the energia software tool. This lab also gives you hands-on experience to use the push buttons and the RGB LED. Requirements: (30 Points) 1. When the push button S1 (J4.33) of the MKlI board is pressed, blink (on and off) the red LED (J4.39) based on the Fibonacci series. (1st press 1 blink, 2nd press 1 blink, 3rd press 2 blinks, 4th press 3 blinks, and so on) 2. When the push button S2 (J4.32) of the MKlI board is pressed, blink (on and off) the green LED (14.38) based on the number of presses. (1st press 1 blink, 2nd press 2 blinks, 3rd press 3 blinks. 4th press 4 blinks, and so on) 3. Each time when the switch S1 or S2 is pressed, generate a beep using the buzzer 4. When push button S1 (P1.1) is pressed, the Fibonacci series and the press count for push button S2 (J4.32) should be reset to zero 2018 Robin Pottathuparambil Page 1 of 2 2/18/2018 5. Push button S1 (J4.33) or S2 (J4.32) will be pushed again only after the blinking event is completed Objectives: This lab introduces the MSP432 board and booster pack from Ti and the energia software tool. This lab also gives you hands-on experience to use the push buttons and the RGB LED. Requirements: (30 Points) 1. When the push button S1 (J4.33) of the MKlI board is pressed, blink (on and off) the red LED (J4.39) based on the Fibonacci series. (1st press 1 blink, 2nd press 1 blink, 3rd press 2 blinks, 4th press 3 blinks, and so on) 2. When the push button S2 (J4.32) of the MKlI board is pressed, blink (on and off) the green LED (14.38) based on the number of presses. (1st press 1 blink, 2nd press 2 blinks, 3rd press 3 blinks. 4th press 4 blinks, and so on) 3. Each time when the switch S1 or S2 is pressed, generate a beep using the buzzer 4. When push button S1 (P1.1) is pressed, the Fibonacci series and the press count for push button S2 (J4.32) should be reset to zero 2018 Robin Pottathuparambil Page 1 of 2 2/18/2018 5. Push button S1 (J4.33) or S2 (J4.32) will be pushed again only after the blinking event is completed