Answered step by step

Verified Expert Solution

Link Copied!

Question

1 Approved Answer

Posted on Aug 05, 2024

One type of descriptive analytics is simply sorting data. Why is seeing extreme values heipful (minimums, maximums, counts, etc) in evaluating accuracy and completeness and

One type of descriptive analytics is simply sorting data. Why is seeing extreme values heipful (minimums, maximums, counts, etc) in evaluating accuracy and completeness and in potentially finding errors and fraud and the like

Step by Step Solution

There are 3 Steps involved in it

Step: 1

Get Instant Access with AI-Powered Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

Step: 3

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Students also viewed these Accounting questions

Question

=+b) Create an R chart based on the calibration data statistics for these 30 samples.

Answered: 1 week ago

Question

★★★★★

Saunders Electronics had the following results for the year just ended: Mr. Saunders, the owner of the store, is unhappy with the operating results. An analysis of other operating costs reveals that...

Answered: 1 week ago

Question

★★★★★

QUESTION 13 OFTE QUESTION How do lower discount factors (interest rates) impact life-cycle cost analysis results? CTTH COUNCIL . The useful project we becomes shorter future operating costs have...

Answered: 1 week ago

Question

★★★★★

see attached please. thank you in advance! O PROBABLY Conditional probability: Basic Suppose that 34% of all adults suffer from diabetes and that 32%, of all adults are obese. Suppose also that 2% of...

Answered: 1 week ago

Question

★★★★★

You are required to design a shell and tube heat exchanger having a rectangular cross section as shown in figure 1 below. The heat exchanger uses water as the cooling fluid to reduce the temperature...

Answered: 1 week ago

Question

★★★★★

The Bakeoff Case Read "The Bakeoff" case and post approximately 1 page of text (about 4 paragraphs) answering the following questions SOLELY based on the case. Do not use other references. What were...

Answered: 1 week ago

Question

★★★★★

1. Determine the magnitude and direction of the force that must be applied to the bottom of the gate shown below to keep the gate closed. 3.4 m Water 1.5 m wide gate Hinge T 0.75 m

Answered: 1 week ago

Question

★★★★★

Lynda is a manager of an investment center. Her division has been performing below expectations recently because one of its larger projects has not been as successful as anticipated. Given the poor...

Answered: 1 week ago

Question

★★★★★

Question 2 Determine the first two critical speeds for the shaft shown in figure 1 below. Young's modulus for steel should be taken as 200GN/m2. Show all the calculations and state all your...

Answered: 1 week ago

Previous Question Next Question