Packet Tracer $(7$ screenshots$)$

Your Goal is to make traffic between two different VLANs

Design and document a Layer $3$ Inter$-$VLAN Routing LAN with: $($Refer to example topology.$)$

Three PCs

One $2960$ Switch

One Multilayer Switch

Use a logical naming and numbering system in your design. $($name$,$ address, port, etc.$)$

Show Device Model Labels, Device Name Labels, Port Labels, Link Lights $($Options $>$ Preferences$)$

Connect all devices

Documentation should be on the topology and include device names$/$models$,$ ports, network addresses

with prefixes, host addresses, passwords, services, and any other pertinent information. For all

parameters not specified, you choose. $($Use notes for information not shown by labels.$)$

Arrange devices and notes so that information can be seen.

Configure Multilayer Switch to correctly route traffic from one VLAN to the other VLAN.

Page $114$ or Section $4\mathrm{.}3\mathrm{.}3$ will help with commands.

Configure on switch:

Set up VLAN $10,20,$ and $30$ using the following names:

$($a$)$ VLAN $10-$ name HSV$/$Students

$($b$)$ VLAN $20-$ name HSV$/$Staff

$($c$)$ VLAN $30-$ name HSV$/$IT

Configure interface$/$ports and set up trunk lines between the switches

$($a$)$ Native VLAN $100$

$($b$)$ Dynamic Desirable

Configure the computers:

Make IP address scheme that is appropriate for each VLAN to communicate.

Verify configurations using appropriate commands.

Verify connectivity between the PCs on different VLANs.