Part 2: Configuring The Devices Now that the devices are properly cabled, they must be configured. Since this system relies on an IP network, the devices must be configured with correct IP information. Since the server is configured to also act as a DHCIP server, the loT devices should be configured as DHCP clients in order to learn IP information automatically Click the solar panel, navigate to the Config tab>> GigabitEthernet0 and select DHCP under IP Configuration Click the power meter, navigate to the Config tab>> FastEthernet0 and select DHCP under IP Configuration Click the battery, navigate to the Config tab>> FastEthernet0 and select DHCP under IP Configuration What IP addresses were learnt by the solar panel, power meter and battery? Before the device can operat e properly, they must register to the server. Configure the devices with the server's IP address to allow them to find and communicate to the server aClick the solar panel, navigate to the Config tab>> Settings and select Remote Server under IoE Server. Enter the following server information