PLEASE ANSWER ASAP

You are expected to design a circuit with an Arduino board, a step motor, a step motor driver, an LDR, and other basic circuit components. Your circuit will input data from LDR process the data output control signals to the step motor. The process phase should be developed so that the following specification is satisfied: At complete darkness your step motors rotor will be assumed to be at degree 0 (angle). At maximum light level the rotor must be at position 200 degrees. At all other light levels, the rotor must be between 0 and 200 degrees where the position is defined by some linear function of the light level. The linear function is up to your design. Note that a complete rotation is 360 degrees. The rotor will never make a complete rotation or more rotations. Rather, it will make necessary number of steps clockwise and counter-clockwise. You must draw your circuit. You must provide the full assembly/C code. You must comment on each line of your source code: C and assembly. You must provide an explanation of how to compile and run your code. You must explain your design with enough level of technical detai