Please help me modify this code to do what 5, 6, and 7 ask of me. TY! I am using a Mega2560 Arduino.

5.Modify the example code to output the signal on both pin 13 and pin 7.

6. Connect an LED and a resistor in series to pin 7, and configure it such that the LED is on when the pin is driven high. Is this LED active high or active low?

7. Connect an LED and a resistor in series to pin 7, and configure it such that the LED is off when the pin is driven high. Is this LED active high or active low?

- 1 x - Blink | Arduino 1.8.13 Let File Edit Sketch Tools Help Blink E > model, check the Technical Specs of your board at: https://www.arduino.cc/en/Main/Products Size modified 8 May 2014 by Scott Fitzgerald modified 2 Sep 2016 by Arturo Guadalupi modified 8 Sep 2016 by Colby Newman 2 KE red This example code is in the public domain. http://www.arduino.cc/en/Tutorial/Blink // the setup function runs once when you press reset or power the board void setup() { // initialize digital pin LED_BUILTIN as an output. pinMode(LED_BUILTIN, OUTPUT); } 7 7 // the loop function runs over and over again forever void loop() { digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second 6 Arduino Mega or Mega 2560, ATmega2560 (Mega 2560) on COM3