Problem 8-65 (Algo) Choosing Between Job Costing and Process Costing (LO 8-7) Franklin Corporation produces a single product. The product is both large and expensive, so few units are produced in any month. The production process requires all material to be brought to the shop floor before any work begins. The material is then processed and assembled and then transferred to finished goods inventory Every unit is completely identical in specification and use, and no customization is possible During March, only three units were started and these were labelled Unit 03-01 Unit 03-02, and Unit 03 03 There was no beginning inventory of any kind on March 1. Records from the raw material store and employee time records show the following requisitions and direct labor costs Unit 03-01 Unit 03-02 Unit 03.03 Direct Material $ 14,000 13,000 15,000 Direct Labor $ 66,090 42,000 30,000 The difference in the material cost represent the historical cost of material purchased at different times. The difference in labor cost represent the difference in cenotty (not skol of the individual employees Overhead for the month of March totaled $207.000 During March Unit 03.01 od 03 OZ were completed and transferred to finished goods Unit 03.03 was still in process on March 31 Required: Subote Pron JOD CON ystem and polles overhead to products on the labor cost what will be the cost of the hits thered to finished good? What we the amount Work Process Enging to b. Suspense costing and Unit 02 03 30 percent complete with respect to consion Cece board overhead consume that mostract B. WH Whost of the transferred to o obete amount Wo Proces Encinante - Required: 2. Suppose Franklin uses a job cost system and applies overhead to products based on direct labor cost. What will be the cost of the units transferred to finished goods? What will be the amount in Work in Process Ending Inventory? b. Suppose Franklin uses process costing and Unit 03-03 was 30 percent complete with respect to conversion cost direct labor and overhead cost) Assume that direct materials cost is not traced to individual units What will be the cost of the units transferred to finished goods? What will be the amount in Work in Process Ending Inventory c. What system tjob costing of process costing would you recommend for Franklin Complete this question by entering your answers in the tabs below. Required Required B Required Suppose Frankines a job cost system and applies gested to products based on direct labor cost. What will be the cost of the units transferred to finished goods? What will be the amount in Work In Process Ending Inventory (Do not found intermediate calculations Cost of goods transferred but Wonen onding into 9700 00.000 3 Complete this question by entering your answers in the tabs below. Required a Required B Required Suppose Franklin uses process costing and Unit 03-03 was 30 percent complete with respect to conversion cost direct laber and overhead cost). Assume that direct materials cost is not traced to individual units. What will be the cost of the units transferred to finished goods? What will be the amount in Work-in-Process Ending Inventory? (Do not round intermediate calculations.) Show less Cost of goods transferred out Work in process ending inventory Required A Required B Required What system (job costing or process costing) would you recommend for Franklin? Job casting Process conting