Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Procedures: Connect electrical wiring of valve displacement measuring kit according to circuit diagram attached with device. Power on the measuring device and check the datum
Procedures:
- Connect electrical wiring of valve displacement measuring kit according to circuit diagram attached with device.
- Power on the measuring device and check the datum reading of each valve.
- Rotate camshaft to TDC of first cylinder. ( The zero mark setting on opposite end of camshaft)
- Rotate camshaft clockwise (looking into the disk from front) to 5. Record displacement of valves starting with initial position at TDC of first cylinder.
- Record the valve lift against camshaft rotating angle for every 5 until 360.
Questions:
Determine the following data from the measuring results
Exhaust valve opening range:__ crankshaft angle to __ crankshaft angle
Intake valve opening range:__ crankshaft angle to __ crankshaft angle
Valve overlap: __ (crankshaft angle)
Maximum lift:__ mm(exhaust) __mm(intake)
2:draw a valve-timing diagram according to the above information
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started