Q4. Draw the wiring connections for the 8-bit DATA IN bus to the input of the 8-bit data register below Q5. DESIGN PROBLEM: Take the output from an &-bit register and design a hardware circuit that will generate an output signal of logic I only when all the register bits are zero. For any other register values, the output signal will be a logic 0The hardware you design could be used to set the zero flag in the 8088 flag register Think back to your Digital Logic course, and remember you have used AND, NAND, OR, NOR and XOR logic gates to design logic for different purposes. Here you may use any combination of these, and all the inverters you like, however you only have 2-input logic gates available. Note that the output signal is labeled "ZERO FLAO Draw your design below by hand. DATA IN DO 8 bit data register D7 Output signal: ZERO FLAG D2 - DI page 17 of20