Question 34 Building a kayak using the composite method Is a very labour-Intenslve process. In the fabrication department, the kayaks go through several steps as employees carefully place layers of Kevlar In a mould and then use resin to fuse together the layers. The excess resin is removed with a vacuum process, and the upper shell and lower shell are removed from the moulds and assembled. The seat, hatch, and other components are added in the finishing department At the beginning of April, Current Designs had 28 kayaks in process in the fabrication department. Rick Thrune, the production manager, estimated that about 80% of the material costs had been added to these boats, which were about 50% complete with respect to the conversion costs. The cost of this inventory had been calculated to be $8,390 in materials and $8,780 in conversion costs During April, 67 boats were started. At the end of the month, the 35 kayaks in the ending inventory had 20% of the materials and 40% of the conversion costs already added to them. A review of the accounting records for April showed that materials with a cost of S 17 75D had been requisitioned by this department and that the cDmverson costs for the manth were S40,6. Complete a production cost report for April 2020 for the fabrication department using the weighted-average method Production Cost Report: Fabrication Department For the Month Ended April 30, 2020 Equivalent Units Quantities Physical Units Materials Conversion Costs Total Work in process, April 1 Started into production Total units Transferred out Work in process, April 30 Total units Costs Total cost Equivalent units Unit costs Work in process, April 1 Started into production Total costs Transferred out Work in process, April 30 Materials Conversion costs Total costs