Question 4 (10 Marks) The Brightlight Corporation uses multicolored molding to make plastic lamps. The molding operation has a capacity of 200,000 units per year. The demand for lamps is very strong. Brightlight will be able to sell whatever output quantities it can produce at $65 per lamp. Brightlight can start only 200,000 units into production in the molding department because of capacity constraints on the molding machines. If a defective unit is produced at the molding operation, it must be scrapped at a net disposal value of zero. Of the 200,000 units started at the molding operation, 15,000 defective units (10%) are produced. The cost of a defective unit, based on total (xed and variable) manufacturing costs incuired up to the molding operation, equals $25 per unit, as follows: Direct materials (variable) $13 per unit Direct manufacturing labour, setup labour, and materials-handling labour (variable) $3 per unit Equipment, rent, and other allocated overhead, including inspection and testing costs on scrapped parts (fixed) $9 per unit Total N Brightlight's designers have determined that adding a different type of material to the existing direct materials would result in no defective units being produced, but it would increase the variable costs by $4 per lamp in the molding department. Required: a. On nancial considerations alone, should Brightlight use the new material? Show your calculations. (6 marks) b. Briey explain two non-financial and/or qualitative factors that Brightlight should consider in making the decision. (4 marks)