R3Using the attached Packet Tracer File, compete the following items. Using the information in the packet tracer file correctly subnet the using the host count identified in the packet tracer Turn on all interfaces and identify all ports that will be used (i.e. drawl out a digram) Using the Starting IP of 192.168.0.0, subnet and build out the address chart below Configure the Banner, and the hostname on all networking devices Configure the IP address accordingly The first useable goes to the router The second useable goes to the computer The interconnect is already configured for you Don't configure Ips for the switches Set up OSPF correctly Submit the deliverables Here is what it looks like for reference 2 Hosts 2960 24TT SUB BRA R2 5000 Hosts PC-PT PC-2 2 Hosts 2960-24TT PC-PT ISR4331 ISR 331 SWA PC-1 R1 2960-24TT SWC2 130 Hosts PC-PT 2 Hosts PC-3-2 60 Hosts 2960-24TT PC-PT SWC1 PC-3-1 62 Hosts Fill in the IP address Chat below Deliverables Step 1 Step 2 Step 3 - Step 3- Network IDs Range Broadcasts Subnet Block/Group 192.168.0.0 192.168.33.128 192.168.33.132 192.168.33.136 192.168.33.140 Screenshot the command for configuring a banner and host name Screenshot a "show run" showing your IP addresses for all three routers (three screenshots here) Screen shot a successful ping from PC-1 to PC-2 & PC-1 to PC-3-2 Port identification What Port is PC-3-1 connected? What Port is SWB using to connect to R2 What port is the DGW for PC-1 What Serial is used to connect R1 to R2 What port is used to connect between the SwC2 switch to the router