Refer to Table 56.1 - Factors for Computing Control Chart Limits (3 sigma) for this problem. Sampling 4 pieces of precision-cut wire to be used in computer assembly) every hour for the past 24 hours has produced the following results: R R R R Hour 1 2 3 4 5 6 3.15 3.10 3.32 3.29 2.97 2.86 0.76" 1.23 1.48 1.26 1.22 0.37 Hour 7 8 9 10 11 12 3.05" 2.55 3.02 2.75 2.83 2.97 0.489 1.18 0.66 1.38 1.22 0.40 Hour 13 14 15 16 17 18 3.11" 2.73 3.12 2.94 2.96 2.64 0.85 1.31 1.01 0.55 1.38 1.29 Hour 19 20 21 22 23 24 3.41" 2.79 2.55 3.38 2.84 2.54 1.56 1.14 1.03 0.41 1.63 1.02 Based on the sampling done, the control limits for 3-sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL;) - inches (round your response to three decimal places). Lower Control Limit (LCL;) - inches (round your response to three decimal places). Based on the x-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL) - inches (round your response to three decimal places). Lower Control Limit (LCLR) - inches (round your response to three decimal places). Based on the R-chart, the wire cutting process has been