Sanderson's Fine Fumishings manulactures upscale custom furniture. Sanderson's currently uses a plantwide overhead rate based on direct labor hours to allocate its $1,000,000 of manufacturing overhead to indlvidual jobs. However, Margaret Garmon, owner and CEO, is considering refining the company's costing system by using departmental overhead rates. Currently, the Machining Department incurs $660,000 of manulacturing overhead while the Finishing Department incurs $340,000 of manulacturing overhead. Garmon has identified machine hours (MH) as the primary manufacturing overhead cost driver in the Machining Department and direct labor (DL hours as the primary cost driver in the Finishing Department. ( 1 (Click the icon to viow the job information.) Read the requirements. Requirement 1. Compute the plantwide overhead rate assuming that Sanderson's expects to incur 20,000 total DL hours during the year. First identify the formula, then compute the rate. (Round your answer to the nearest whole dollar.) Requirements 1. Compute the plantwide overhead rate assuming that Sanderson's expects to incur 20,000 total DL hours during the year. 2. Compute departmental overhead rates assuming that Sanderson's expects to incur 15,000MH in the Machining Department and 17,000 DL hours in the Finishing Department during the year. 3. If Sanderson's continues to use the plantwide overhead rate, how much manufacturing overhead would be allocated to Job 450 and Job 455 ? 4. If Sanderson's uses departmental overhead rates, how much manufacturing overhead would be allocated to Job 450 and Job 455? 5. Based on your answers to Requirements 3 and 4 , does the plantwide overhead rate overcost or undercost either job? Explain. If Sanderson's s6i's its furniture at 125% of cost, will its choice of allocation systems affect product pricing? Explain. More info The Sanderson's plant completed Jobs 450 and 455 on May 15. Both jobs incurred a total of 5DL hours throughout the entire production process. Job 450 incurred 3MH in the Machining Department and 4DL hours in the Finishing Department (the other DL hour occurred in the Machining Department). Job 455 incurred 4MH in the Machining Department and 3 DL hours in the Finishing Department (the other two DL hours occurred in the Machining Department)