Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 9.09 Volts and is running at a frequency of f = 1.138e+04 Hz. The resistor has a resistance of R = 2100 0 and the capacitor has an capacitance of C = 5.84e-09 Farads. R WW C VpsWrite the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit z = Determine the numerical value of Ztot = Determine the numerical value of ?Ztot = degrees Determine the current through the circuit: . I(PEAK) = Amps . I(RMS) = Amps Determine the voltage across the resistor: . VR(PEAK) = Volts . VR(RMS) = Volts Determine the voltage across the capacitor: Vc(PEAK) = Volts . Vc(RMS) = Volts If a second circuit were connected in parallel with the capacitor, this circuit would be considered as: a radio tuner O a capacitive switcher O a flux capacitor O a low-pass filter O a phase conjugate deflector O a high-pass filter NOTE: In your formulas, use variables R, w, and C. Do not use f. Be careful with signs, even in your formulas