Some parts manufactured in an injection molding process are subjected to a certain compressive strength test. 22 samples are taken as shown in the following table which shows the compressive strengths (in psi). Assume that you want to analyze using an xbar-s charts. u-) (4 points) If the 3 sigma control limits are replaced with 2 sigma limits, What is the UCL for the new X control chart (based on the original data)? (use 2 decimals) v) (4 points) If the company decides to change the of doing their control limits to become probability based limits and chose to make them based on a 0.001 type I error, What is the LCL for the new X control chart? (use 2 decimals) w) (4 points) If the company decides to change the of doing their control limits to become probability based limits and chose to make them based on a 0.001 type I error, What is the UCL for the new X control chart? (use 2 decimals)