Step 1: Initialize and reload router and switch (2 pts) The devices will automatically initialize when the Netlab Reservation is entered. If you were working in the lab What commands would you use? (Short cuts are OKI) Include the prompt at which the command will be run.. >, \#, (config)\#, (config-iott, (config-line)\# Step 4: Configure S2 ( 13pts)1/2 pts will be earned here, 1/2 pts will be eamed by configuration Include the prompt at which the cornmand will be run.. (corfig) H, (config-line) H, (config-if) H Step 3: Configure S1 (13 pts) 1/2 pts will be earned here, 1/2 pts will be eamed by configuration Include the prompt at which the command will be run... (config)\#, (config-line)\#, (config if)\# Step 2: Configure R1 (19 pts) 1/2 pts will be earned here, 1/2 pts will be earned by configuration