Step 2: Use the show interface command to examine the network interfaces. a. Use the show interface gigabitFthernet 0/0 command to see the status of the Gigabit Ethernet 0/0 interface. Note: After typing part of the command, for example, show interface g, you can use the Tab key on your keyboard to complete the gigabitEthernet command parameter. Router\# show interface gigabitEthernet 0/0 Gigabitethernet0/0 is administratively down, line protocol is down Hardware is CN Gigabit Ethernet, address is 442b.031a.b9a0 (bia 442b.031a.b9a0) MTU 1500 bytes, BW 100000Kbit/sec, DLY 100 uses, reliability 255/255, txbad 1/255, Exboad 1/255 Encapsulation ARPA, loopback not set Keepalive set (10sec) Full Duplex, 100Mbps, media type is RJ45 output flow-control is unsupported, input flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fijfa Output queue: 0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 3 packets input, 276 bytes, 0 no buffer Received 0 broadcasts ( 0 IP multicasts) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0multicast,0 pause input 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 unknown protocol drops 0 babbles, 0 late collision, 0 deferred o lost carrier, 0 no carrier, 0 pause output 0 output buffer failures, 0 output buffers swapped out b. Given the output of the show interface gigabitFtheroet 0/0 command depicted above, or using the output from your router, answer the following questions: [Report] What is the hardware type and MAC address of the Gigabit Ethernet interface? [Report] What is the interface media type? Is the interface up or down