Study the scenario and complete the questions that follow:

Implementing VLSM$,$ VLAN Interconnection, OSPF Configuration

Implementing VLSM$,$ VLAN Interconnection, OSPF Configuration, and Connectivity Verification in a University Network. As a network administrator at a prestigious university, you have been tasked with planning and implementing a robust network infrastructure that supports Variable Length Subnet Masking $($VLSM$),$ VLAN interconnecti

The IP addresses for all devices are given for you in the address table below.

$\backslash$table$[[$DEVICE$,$INTERFAC,EIP ADDRESS,SUBNET MASK,$\backslash$table$[[$DEFAULT$],[$GATEWAY$]]],[$Router$1,Fa\frac{0}{0\mathrm{.}10},,,\frac{N}{A}$on$,$ OSPF configuration, and connectivity verification. Upon completion of this lab, you will be able to effectively plan for IP addresses using VLSM$,$ configure VLAN interconnection, implement OSPF, and verify connectivity within the university network.

Lab Objectives:

Plan for IP addresses using VLSM to efficiently allocate address space within the university network. Configure VLAN interconnection to facilitate communication and resource sharing between different departments and segments.

Implement OSPF as the dynamic routing protocol to ensure optimal routing and connectivity within the network.

Verify end$-$to$-$end connectivity and data transfer to ensure that the network infrastructure is functioning as intended.

Topology Diagram

Complete the below Tasks using Cisco Packet Tracer.

TASK $1$: Create and cable the network.

TASK $2$: Design IP address plan

The network address $172\mathrm{.}30\mathrm{.}0\mathrm{.}0/16$ is given. You need to design an IP plan for the network illusi Figure$1$ above using VLSM$.$ Take note of the following:

$.$ VLAN $10($tut$)$ has $200$ users

VLAN $20($vut$)$has $100$ users

$,$ VLAN $30($dut$)$has $250$ users

$,$ WAN$1$ has $2$ users

WAN$2$ has $2$ users

WAN$3$ has $2$ users

VLAN $10($TUT$)$

$\backslash$table$[[$Subnet address,$\backslash$table$[[$First usable$],[$address$]],\backslash$table$[[$Last usable$],[$address$]],$Subnet mask$],[,,,]]$

VLAN $20($VUT$)$

$\backslash$table$[[$Subnet address,$\backslash$table$[[$First usable$],[$address$]],\backslash$table$[[$Last usable$],[$address$]],$Subnet mask$],[,,,]]$

VLAN $30($DUT$)$

$\backslash$table$[[$Subnet address,$\backslash$table$[[$First usable$],[$address$]],\backslash$table$[[$Last usable$],[$address$]],$Subnet mask$],[,,,]]$