Question
Suppose there are 6 LEDs hooked up to Arduino digital pins 3-8. Using for() loops, write a sketch that would turn the LEDs on for
Suppose there are 6 LEDs hooked up to Arduino digital pins 3-8. Using for() loops, write a sketch that would turn the LEDs on for 0.5 seconds at a time in order, 3-8, and reverse order, 8-3, indefinitely. Refer to the pseudocode below to understand how the LEDs should behave:
Setup Declare digital pins 3-8.
Loop
Turn on first LED for 0.5 seconds. Turn off first LED.
Turn on second LED for 0.5 seconds. Turn off second LED.
Turn on third LED for 0.5 seconds. Turn off third LED.
Turn on fourth LED for 0.5 seconds. Turn off fourth LED.
Turn on fifth LED for 0.5 seconds. Turn off fifth LED.
Turn on sixth LED for 0.5 seconds. Turn off sixth LED.
Turn on fifth LED for 0.5 seconds. Turn off fifth LED.
Turn on fourth LED for 0.5 seconds. Turn off fourth LED.
Turn on third LED for 0.5 seconds. Turn off third LED.
Turn on second LED for 0.5 seconds. Turn off second LED.
Turn on first LED for 0.5 seconds. Turn off first LED.
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started
Essentials of Database Management
Authors: Jeffrey A. Hoffer, Heikki Topi, Ramesh Venkataraman
1st edition
133405680, 9780133547702 , 978-0133405682
