Task 1: Single-phase half-wave phase-controlled rectifier with RL load 1. Make a new project. Use same simulation set up with the previous example. 2. Build a single-phase half-wave phase-controlled rectifier with series RL load (R = 0.5, L= 1mH) using 2N1595. Connect negative port of VSIN (50V, 60Hz) to Ground. Set the firing angle at 60. 3. Plot source voltage, load voltage, load current, voltage across the thyristor, and gate voltage. Reproduce Figure 8. 4. Include the schematic and output waveforms in your report and explain the result