Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

The desired distance for Flextronchip customers is 0.2 mm between two adjacent pins. Any deviation from this value causes interference. The process of handling

imageimageimage

The desired distance for Flextronchip customers is 0.2 mm between two adjacent pins. Any deviation from this value causes interference. The process of handling complaints costs the firm at approximately $40.00 per chip. The engineers of the firm expect the average customer will be likely to complain when the distance is off target by at least 0.0001 mm. At the factory, the adjustment can be made at a cost of $1.60, which includes the labor to make the adjustment and additional testing. Required: 1. What is the value of k, the cost coefficient, in the Taguchi quality loss function (QLF) based on the above data? 2. Based on a Taguchi quality loss function (QLF), what should the tolerance be before an adjustment is made at the factory? 3. Based on your answer to (requirement 2) above, what are the specification limits (upper and lower) for the production of the product in question? Complete this question by entering your answers in the tabs below. Required 1 Required 2 Required 3 What is the value of k, the cost coefficient, in the Taguchi quality loss function (QLF) based on the above data? (Do not round intermediate calculation.) Value of k < Required 1 Required 2 > The desired distance for Flextronchip customers is 0.2 mm between two adjacent pins. Any deviation from this value causes interference. The process of handling complaints costs the firm at approximately $40.00 per chip. The engineers of the firm expect the average customer will be likely to complain when the distance is off target by at least 0.0001 mm. At the factory, the adjustment can be made at a cost of $1.60, which includes the labor to make the adjustment and additional testing. Required: 1. What is the value of k, the cost coefficient, in the Taguchi quality loss function (QLF) based on the above data? 2. Based on a Taguchi quality loss function (QLF), what should the tolerance be before an adjustment is made at the factory? 3. Based on your answer to (requirement 2) above, what are the specification limits (upper and lower) for the production of the product in question? Complete this question by entering your answers in the tabs below. Required 1 Required 2 Required 3 Based on a Taguchi quality loss function (QLF), what should the tolerance be before an adjustment is made at the factory? (Do not round intermediate calculations. Round "Target value" to 1 decimal place and round "Tolerance" answer to 5 decimal places.) Tolerance < Required 1 Required 3 > Required 1 Required 2 Required 3 Based on your answer to (requirement 2) above, what are the specification limits (upper and lower) for the production of the product in question? (Round your answers to 5 decimal places.) Upper specification limit Lower specification limit

Step by Step Solution

There are 3 Steps involved in it

Step: 1

Here are the stepbystep calculations 1 Value of k in Taguchi QLF Given Com... blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Cost management a strategic approach

Authors: Edward J. Blocher, David E. Stout, Gary Cokins

5th edition

73526940, 978-0073526942

More Books

Students also viewed these Finance questions

Question

112 S cos-(2x) dx

Answered: 1 week ago