. The figure, below, shows all units, of the minimum hardware required, for multiplying two 3-bit numbers. The figure, does not show the connecting buses and control lines. Do not draw them.| Binary Multiplication: 001 x 001 is executed. The Hardware shown below, indicates the version of multiplication you will do. * 5 pts] Complete below, in the figure, the Name, the Size and the Initial value of each unit. To do the above do the following: Backspace and delete the word Size in each unit and type the size of each unit. If there is no Size, for a unit, just delete the word Size from that unit. Backspace and delete Name of Unit and type the real name of each unit. If there is no Name, for a unit, just delete the word Name from that unit. Backspace and delete Initial value and type the Initial value for each unit. If there is no Initial value, for a unit, just delete the word Initial value from that unit. Name of Unit Size Initial value Name of Unit Size Initial value Name of Unit Size Initial value Name of Unit Size Initial value * | 7 pts] Complete the table below, showing all steps, of the multiplication of two 3-bit numbers, (001 x 001). The multiplication is done using the hardware above. There are many columns and many rows in the Table below. Use as many columns as you need. Use as many rows as you need. You may NOT need all columns and rows. Iteration Step Initial values