The second part of this homework is a program that should be written per the description below and

turned in to the Canvas assignment for Homework #$3.$ Turn in just a single C source code file for the

assignment. The program will be tested with gcc under Cygwin.

Write a program that takes two command line arguments at the time the program is executed. You

may assume the user enters only signed decimal numeric characters. The input must be fully qualified,

and the user should be notified of any value out of range for a $28-$bit unsigned integer. The first

argument is to be considered a data field and the second is a mask used to perform bit$-$wise operations

on the data field. The program should display a menu that allows the user to select different bit$-$wise

operations to be performed on the data field. The required operations are: Set, Clear and Toggle. Both

data and mask should be displayed on screen in binary format. And they must be displayed such

that one is above the other so that they may be visually compared bit by bit. If data and mask are both

within the range for unsigned $8-$bit values, then the binary display should only show $8$ bits. If both

values are within the range for unsigned $16-$bit values, then the binary display should only show $16$ bits.

The menu must also allow the user to re$-$enter a value for data and re$-$enter a value for the mask. Use

scanf$()$ to read data from the user at runtime and overwrite the original values. All user input must be

completely qualified to meet the requirements above $($up to $28-$bit unsigned integer values$).$

Printing binary must be done with shifting and bitwise operations. Do NOT use arrays. No

multiplication or division is needed to produce binary output to the screen.