The specifications for position for the center point of three holes on a "Support Plate" are as follows: For hole 1: From datum C: x basic = 1.000, and from datum Bybasic = 1.000. For hole 2: - From datum C: x-basic = 7.000, and from datum By-basic-2000. For hole 3 From datum C: x basic = 1.000, and from datum By-basic-3.000. The "Support Plate" was made and measured. The location of the center point of the three holes were as follows: For hole 1: From datum : x = 0.994 , and from datum B y = 1.115. For hole 2: From datum : x = 7.009, and from datum B y 1.994. For hole 3: From datum C: x = 0.999, and from datum B y = 3.020. What is the "diameter position error, Z" for hole 1